Filament Diameter: 1.75mm (as measured, pretty spot on).Default Printing Speed: 30mm/sec (printing at faster speeds requires hotter print temps to get the filament melted in time).Weird they split the settings into multiple tabs…) Wipe Nozzle: On (This pairs with the wipe setting in the Advanced tab, below.But this is for their default (smaller) nozzle\hotblock, and the Volcano is already 10mm longer than it, so a 10mm retraction has been working ok. Note, the “ E3D-v6 Troubleshooting Guide” says not to use retractions over 5mm, since they can pull the filament into the cold-zone.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |